Automatic Mode - Acova Z23020 Notice D'utilisation

RF_prog:RF_prog_ACOVA_7L 22/10/2010 09:19 Page39

3.4 Automatic mode

This mode should be used if you wish to change between modes (
automatically to suit your schedule. When in this mode, your appliance is
operated according to the program entered previously (see section 3.3).
Room temperature
TURN THE DIAL TO AUTO
On first use, the display will show the room temperature measured by the
thermostat. The
Press the 1 button to display the setpoint (desired) temperature.
It is possible to change which temperature is shown on the display (see section
4.2):
– in automatic mode: setpoint temperature
– press the
i
If you wish to deviate from the program (see section 3.3), you can switch to
permanent
ECO
mode (
PROTECTION
Time
Away mode
Mode switch
symbol is displayed above the °C symbol.
button: room temperature
mode ( ), permanent
) by turning the dial to the desired mode.
Current setpoint (e.g. Comfort)
Day
Heat command active
Room temperature/
setpoint temperature display
Manual mode (from 30 min. to 72 hours)
mode ( ) or permanent
COMFORT
and )
EN
FROST
39