Acova Z23020 Notice D'utilisation page 46

RF_prog:RF_prog_ACOVA_7L 22/10/2010 09:20 Page44
4.6 Associating the appliance
Your appliance must be associated with the
room thermostat to ensure that it receives
commands from this device only and is not
subject to interference from other radio
frequency control devices.
IMPORTANT It is vital that the appliance is
associated with the room thermostat if it is
to function correctly.
When you connect your device to the power supply, the TH light on the radio
receiver (to the rear of the radiator) will blink.
NOTE If the
(reset).
Every radiator that is powered up but not associated with a thermostat will automa-
tically be associated with this room thermostat. You can use your distribution board
EN
to supply power only to those radiators you want to associate.
The light is blinking (radiator not associated)
From room thermostat menu CF06, press the + button. The X2D symbol appears
briefly when an association signal is transmitted. Check that the light on the
receiver has stopped blinking and is glowing steadily.
Your appliance is now associated with the room thermostat.
NOTE To disassociate your appliance from the thermostat, press button
seconds to reset it. This will cancel the association.
Press OK to move to the next menu.
44
with the room thermostat (CF06)
TH
light is glowing steadily, press for 60 seconds until it starts blinking
The light glows steadily when the association signal
from the thermostat has been received
for 60