Setting The Time - Acova Z23020 Notice D'utilisation

RF_prog:RF_prog_ACOVA_7L 22/10/2010 09:19 Page35
2.2 Activating and replacing the batteries
Lever off the cover using a screwdriver (A).
Remove the battery insulation tab and replace the
cover.
When the low battery indicator
have approximately three months to change the
batteries (2x 1.5V alkaline batteries of type LR03
or AAA).
You should take the following precautions:
– ensure correct +/- polarity when inserting batte-
ries into the thermostat
– take care when disposing of used batteries:
protect the environment by disposing of them at
an approved collec tion point
– do not recharge the batteries
– you have approximately 45 seconds to insert new
batteries before your time and date settings are
lost (if this happens, the time and date settings
must be re-entered).

2.3 Setting the time

Turn the dial to
The days will blink. Press + or – to select the
required day (Monday can be taken as day 1) then
press OK to confirm and move on to the next
setting.
Follow the same procedure to set the hours and
then the minutes.
Turn the dial to exit the settings mode.
NOTE Your appliance and the room thermostat
must be associated with each other before they will
work together (see section 4.6).
appears, you
.
-
AUTO
+
B
PRO PROG +
-
Low battery
indicator light
Hour
Minutes
Day
35
EN