Acova Z23020 Notice D'utilisation page 47

RF_prog:RF_prog_ACOVA_7L 22/10/2010 09:20 Page45
4.7 Radio signal test (CF07)
The room thermostat sends a signal to the
radio receiver on your appliance every 3
seconds. The X2D symbol appears briefly on
the display as it does so. Check that the TH
light on the receiver blinks each time a
signal is received. This confirms that the
association process has been successful (see
section 4.6).
TO EXIT THE ADVANCED SETTINGS FUNCTION AT ANY TIME, TURN THE DIAL.
4.8 Restoring the thermostat to the factory settings
Restarting the thermostat will restore the
following values to their factory settings:
the advanced settings (shaded in the CF
menus), the setpoint temperatures and the
default program.
Turn the dial to
leftmost button for 10 seconds until "init"
is displayed.
Press OK to confirm or C to cancel. The
mode display will then reappear.
NO HEAT
TECHNICAL SPECIFICATIONS OF THE ROOM THERMOSTAT
_ Powered by 2x 1.5 V alkaline batteries, type LR03 or AAA (supplied), battery life
over 2 years under normal use.
_ Remote control device with radio range of 100 to 300 metres free field depending
on equipment associated with it (range may be reduced by the installation
conditions and the electromagnetic environment).
_ Operating temperature: 0°C to 40°C.
_ Signal frequency 868 MHz, class I (standard EN 300 220).
and press the
NO HEAT
10 sec.
45
EN