Preparing The Weather Station For Use - Auriol Z31915 Instructions D'utilisation Et Consignes De Sécurité

Preparing the weather station for use

Removing the battery safety strip:
Open the battery compartment
Pull out the battery safety strip.
Then close the battery compartment.
As soon as the battery safety strip has been removed, the weather station starts to
receive the radio signal.
Note: Do not move the weather station while it is receiving the signal. This may
disrupt reception.
Connecting the weather station with the outdoor sensor and the
DCF radio signal:
After removal of the battery safety strip the weather station attempts to establish a
connection with the outdoor sensor. This process can take a few minutes. On successful
connection with the outdoor sensor, the selected channel symbol
LC display with the channel of the outdoor sensor (if necessary you can change the
channel of the outdoor sensor as shown in the section "Setting the channel"). If the
connection with the outdoor sensor is not established automatically, this can be done
manually by pressing RESET button
on the back of the weather station.
40
of the sensor.
43
appears in the
27
GB/IE 17