Note: Make sure you fit the batteries the
right way round (polarity). This is shown
in the battery compartment (see. fig D).
The outdoor sensor is now ready for use
and the control LED
Close the battery compartment cover.
If this does not work, carry out a restart,
if necessary. To do this, press and keep
pressed the Z
Preparing the temperature
station for use
Inserting the batteries:
Open the battery compartment
back of the temperature station.
Insert two 1.5 V
cluded) into the battery compartment.
Note: Make sure you fit the batteries the
right way round (polarity). This is shown
on the battery compartment (see. fig B).
Close the battery compartment cover.
Connecting the temperature station
with the outdoor sensor and the DCF
radio signal:
After the batteries have been inserted, the
temperature station attempts to establish a
connection with the outdoor sensor. This pro-
cess can take a few minutes. The
flashes. Once the device has successfully con-
nected to the external sensor, the
stops flashing and the temperature is shown
in the LC display.
14 GB/IE
illuminates briefly.
28
Z
/ REGISTER button
batteries (AA) (in-
.
18
on the
24
symbol
symbol