Motor Protection; Electrical Fault; Fault Check List; Maintenance / Disposing - Intimus 175 hybrid 297-1CH Instructions D'opération

GB

4 .3 Motor protection

Should the motor be overloaded it switches off. The
control display (fig. 3/3) comes on. The machine can
be started again after a cooling down period of about
15 – 20 minutes (depending on the model and the
room temperature).

4 .4 Electrical fault

If the function button (fig. 3/1) LED display
only the control display
electrical fault.
1 . Switch off the machine once.
2 . Turn the machine on again.
¾ This helps in many cases.
If the machine still fails to start up, please notify your
dealer.

4 .5 Fault check list

Should the machine not work, check the following
points:
• is the plug connected to the power supply?
• is the door closed?
• is the receptacle full?
¾ Follow the instructions under „Emptying the CD
receptacle", p. 15 or „Emptying the paper recep-
tacle", p. 15.
• Is there a material jam in the machine?
¾ Follow the instructions in „Material jam in the
machine", p. 16.
• Is the motor overloaded?
¾ See „Motor protection", p. 17.
NOTE!
In many cases, restarting the machine helps:
1 . Switch off the machine once.
2 . Turn the machine on
If none of these test points apply, please contact your
dealer.
93901 5 01/18
flashes or
(fig. 3/7) flashes there is an
again.
5

Maintenance / Disposing

5 .1 To change the oil container

Cross-cut cutting mechanisms must be oiled regularly
after a certain period of operation. This is done auto-
matically by the integrated oiler.
If the control display (fig. 3/8) flashes, this means that
the oil container (fig. 6/3) is empty and must be repla-
ced with a full container. The motor switches off.
NOTE!
To complete the shredding process when the
motor is switched off, press and hold the for-
ward button (fig. 3/2).
¾ The cutting mechanism continues to
run forward for approx. four seconds.
This process can only be activated once.
Changing the oil container:
1 . Open the door.
¾ The control display
¾ The control display for the reverse button
(fig. 3/6) flashes.
1
Oil hose
2
Cap
3 Oil container
fig. 6 Oil container
2 . Change the oil container (fig. 6/3). To do this, un-
screw the cap (fig. 6/2).
3 . Press the reverse button (fig. 3/6).
¾ The control display (fig. 3/6) goes out.
4 . Close the door.
¾ The control display
¾ The control display (fig. 3/8) goes out.
The machine is ready for use again. Should you need
to re-order the special oil see „Accessories", p. 18.
175 hybrid
(fig. 3/7) comes on.
1
2
3
000080
(fig. 3/7) goes out.
17