Operation; Controls - Intimus 175 hybrid 297-1CH Instructions D'opération

GB
3

Operation

3 .1 Controls

1
10
9
8
7
1
Functions button
2
Forwards button
3
Control display „Motor overload" / „Electrical fault"
4
Control display „Collection bin CD full"
5
Control display „Collection bin paper full"
6
Reverse button
7
Control display „Door open" / „Door malfunction"
8 Control display „To change the oil container" / „Oil
sensor defective"
9
Control display „Material jam"
10
Control display „Load level of the motor"
fig. 3 Controls „i-control"
= Functions button (fig . 3/1)
1
a) „Ready"
The machine changes to "Ready" if you press this
button briefly. At the same time the integral LED
display comes on.
b) „Off"
The machine switches off if it is in the "Ready"
mode and the button is held down for about 3
seconds.
NOTE!
The machine switches off automatically if it is
not used for about 15 minutes.
c) „Stop"
If you press this button briefly when the cutters
are running they switch off and stop.
= Forwards button (fig . 3/2)
2
If this button is pressed, the cutting mechanism
runs forwards for a few seconds, e.g. to remove re-
maining material from the cutting mechanism. At
the same time the integrated LED display
up.
By pressing and holding this button when the mo-
tor has stopped, the cutting mechanism runs for-
wards.
93901 5 01/18
= Control display (fig . 3/3) „Motor overload" /
3
„Electrical fault"
To find out what to do see the relevant description
under the section „Malfunctions", p. 16.
a) „Motor protection"
Comes on when the motor has been overloaded
and has switched off. The machine cannot be
2
started while the motor is cooling down.
b) „Electrical fault"
3
Flashes when there is an electrical fault inside
the control board. The machine switches off.
4
Please contact your dealer.
5
= Control display (fig . 3/4) „Collection bin CD
4
6
full"
Lit when the collection bin CD is full and needs to
000077
be emptied. The cutter is switched off.
= Control display (fig . 3/5) „Collection bin paper
5
full"
Lit when the collection bin paper is full and needs
to be emptied. The cutter is switched off.
= Reverse button (fig . 3/6)
6
a) „Stop"
If you press this button briefly when the cutters
are running they switch off and stop.
b) „Reverse"
By pressing and holding this button when the
motor has stopped, the cutting mechanism runs
in reverse. The integrated LED indicator
up at the same time.
= Control display (fig . 3/7)
7
a) „Door open"
Comes on if the door on the lower part of the
machine is opened. The motor switches off au-
tomatically and cannot be started as long as the
door remains open.
b) „Door malfunction"
Flashes when there is an electrical fault in the
door sensor. The motor switches off. Please con-
tact your dealer.
= Control display (fig . 3/8)
8
a) „To change the oil container"
The control display flashes when the oil contai-
ner is empty and must be replaced with a full
container. The motor is switched off. The oil con-
tainer change must be acknowledged on the
lights
reverse button (see „To change the oil container",
p. 17).
175 hybrid
lights
13