Wiring Connection; Important; Remote Control (Rm-Rk52) - JVC KD-R980BTS Manuel D'instructions

Wiring connection

IMPORTANT

We recommend installing the unit with a commercially available custom
wiring harness specific for your car and leave this job to professionals for your
safety. Consult your car audio dealer.
Vehicle
dashboard
Factory wiring
harness (vehicle)
Custom wiring
harness
Blue: To power antenna
(separately
Blue/white: To amplifier
purchased)
Brown
Recommended connection
Antenna terminal
To the steering wheel
remote control adapter
Join the same color wires together.
Blue/white: Remote (200 mA max.)
Orange/white: Illumination
(Not used)
Yellow: Battery 12 V
Red: Ignition 12 V
Black: Ground
Gray: Front speaker/For 3-way crossover: mid range speaker (right)
Gray/black
White: Front speaker/For 3-way crossover: mid range speaker (left)
White/black
Purple: Rear speaker/For 3-way crossover: Tweeter (right)
Purple/black
Green: Rear speaker * 2
2
Green/black *
Output terminals ( 34)
Fuse (10 A)
Light blue/yellow
STEERING
WHEEL
REMOTE
/For 3-way crossover: Tweeter (left)
Signal cord (not supplied)
For KD-R980BTS:
MIC (microphone input terminal)
( 14)
For KD-R980BTS:
Expansion port (12 V
To the optional SiriusXM Vehicle Tuner
(commercially available) ( 11)
For KD-R880BT:
Microphone input jack ( 14)
Remote wire (not supplied)
Ignition switch
Car fuse block
Separate red wire
Make this connection if your vehicle factory wiring
harness does not have "12 V ignition switch" wire.
*
1
Firmly connect the ground wire of the amplifier to the
car's chassis to avoid damaging the unit.
*
2
You can also connect a subwoofer speaker directly
using this lead without an external subwoofer
amplifier. For setting, 24.
1
JVC Amplifier *
500 mA)
35
ENGLISH