JVC KD-R980BTS Manuel D'instructions page 20

BLUETOOTH®
To
While talking on the first incoming call...
Answer another incoming
call and hold the current
call
Reject another incoming
call
While having two active calls...
End current call and
activate held call
Swap between the
current call and held call
Adjust the phone volume
[00] to [35] (Default: [15])
Switch between hands-free
and private talk modes
Improve the voice quality
While talking on the phone....
1
Press and hold .
2
Turn the volume knob to select an item (see the following table), then press
the knob.
3 2
Repeat step until the desired item is selected or activated.
4
Press to exit.
To return to the previous setting item, press
16
ENGLISH
On the faceplate On the remote control
Press or the volume
( Not available )
knob.
Press and hold or
( Not available )
the volume knob.
Press and hold
Press and hold or
the volume knob.
Press .
( Not available )
Turn the volume knob
during a call.
• This adjustment will not ( Not available )
affect the volume of the
other sources.
Press during a call.
• Operations may vary
according to the ( Not available )
connected Bluetooth
device.
.
MIC GAIN LEVEL –10 to LEVEL +10 (LEVEL –4): The sensitivity of the
microphone increases as the number increased.
NR LEVEL LEVEL –5 to LEVEL +5 (LEVEL 0): Adjust the noise reduction
level until the least noise is being heard during a phone
conversation.
ECHO CANCEL LEVEL –5 to LEVEL +5 (LEVEL 0): Adjust the echo
cancellation delay time until the least echo is being heard
during a phone conversation.
Make the settings for receiving a call
.
1
Press to enter Bluetooth mode.
2
Turn the volume knob to select an item (see the following
table), then press the knob.
3 2
Repeat step
To return to the previous setting item, press
SETTINGS
AUTO ANSWER 01 SEC to 30 SEC: The unit answers incoming call
automatically in the selected time (in seconds). ; OFF: Cancels.
RING COLOR (For KD-R980BTS)
COLOR 01 to COLOR 49 (COLOR 08): Selects the light color
for the buttons as notification when there is an incoming call
and during a call. ; OFF: Cancels.
RING ILLUMI (For KD-R880BT)
BLINK 1 to BLINK 5 (BLINK 2): Selects the blinking pattern
for the buttons as notification when there is an incoming call. ;
OFF: Cancels.
BATT/SIGNAL* AUTO: Shows the strength of the battery and signal when the
unit detects a Bluetooth device and the Bluetooth device is
connected. ; OFF: Cancels. Clock time is shown.
* Functionality depends on the type of the phone used.
until the desired item is selected or activated.
Default: XX
.
Default: XX