JVC KD-R980BTS Manuel D'instructions page 35

TROUBLESHOOTING
Symptom Remedy
"CHECK ANTENNA" Check that the antenna and its connection are in good
condition.
"CHECK TUNER" Make sure the SiriusXM Vehicle Tuner is connected to
the unit.
"NO SIGNAL" Make sure the antenna is mounted outside the vehicle.
"SUBSCRIPTION UPDATED Your subscription is updated. Press the volume knob to
– PRESS ENTER TO continue.
CONTINUE."
"CODE ERROR" Make sure you have entered the correct pass code.
( 13)
"NO CONTENT" There is insufficient content to start TuneScan.
"SCAN CANCEL" TuneScan has been aborted.
No Bluetooth device is • Search from the Bluetooth device again.
detected. • Reset the unit. ( 3)
Pairing cannot be made. • Make sure you have entered the same PIN code to both
the unit and Bluetooth device.
• Delete pairing information from both the unit and the
Bluetooth device, then perform pairing again. ( 14)
Echo or noise occurs. • Adjust the microphone unit's position. ( 14)
• Check the [ECHO CANCEL] setting. ( 16)
Phone sound quality • Reduce the distance between the unit and the Bluetooth
is poor. device.
• Move the car to a place where you can get a better
signal reception.
Sound is being • Reduce the distance between the unit and the Bluetooth
interrupted or skipped audio player.
during playback of a • Turn off, then turn on the unit and try to connect again.
Bluetooth audio player. • Other Bluetooth devices might be trying to connect to
the unit.
Symptom Remedy
The connected • Check whether the connected Bluetooth audio player
Bluetooth audio supports Audio/Video Remote Control Profile (AVRCP).
player cannot be (Refer to the instructions of your audio player.)
controlled. • Disconnect and connect the Bluetooth player again.
"PAIRING FULL" The number of registered devices has reached its limit.
Retry after deleting an unnecessary device. ( 18, DEVICE
DELETE)
"PLEASE WAIT" The unit is preparing to use the Bluetooth function. If the
message does not disappear, turn off and turn on the unit,
then connect the device again.
"BT DEVICE NOT The unit failed to search for the registered Bluetooth
FOUND" devices during [RECONNECT]. Turn on Bluetooth from your
device and connect manually. ( 18)
"NOT SUPPORT" The connected phone does not support Voice Recognition
feature.
"ERROR" Try the operation again. If "ERROR" appears again, check if
the device supports the function you have tried.
"H/W ERROR" Reset the unit and try the operation again. If "H/W ERROR"
appears again, consult your nearest service center.
If you have any troubles, try the following:
1 Check TROUBLESHOOTING
2
Reset the unit ( 3)
3
Contact (USA only)
Call: 1-800-252-5722 ( or ) visit: <http://www.jvc.com>
31
ENGLISH