Ugolini MT GL Manuel D'instructions page 14

MT GL/GLS
fastening hooks (see figure 5) and slide it out (see figure 6).
3 Slide the outer spiral out (see figure 7) and then the inside
auger (see figure 8).
figure 5
figure 6
figure 7
figure 8
4 Remove the bowl gasket from its seat (see figure 9).
5 Dismantle the faucet assembly (see figure 10).
6 Slide the drip tray out and empty it.
5. 3. 2 CLEANING
IMPORTANT
Do not attempt to wash any machine components in a
dishwasher.
ATTENTION
Before any disassembly and/or cleaning procedure make
sure that the dispenser is disconnected from its power
source.
1 Prepare at least two gallons of a mild cleaning solution of
warm (45-60 °C 120-140 °F) potable water and dishwashing
detergent. Do not use abrasive detergent.
Important: if present, follow label directions, as too strong a
solution can cause parts damage, while too mild a solution will
not provide adequate cleaning.
IMPORTANT
In order to prevent any damages to the dispenser use
only a detergent suitable with plastic parts.
2 Using a brush, suitable for the purpose, thoroughly clean all
14
figure 9
figure 10