Connecting The Generator - Dometic TEC40D EV Instructions De Montage

TEC40D EV
• Select the cross-section of the cable as follows:
– 230 V: 4 mm²
– Battery charger: 2.5 mm²
– Starter battery connection (length < 6 m): 16 mm²
– Starter battery connection (length > 6 m): 25 mm²
• Install a manual main switch which can disconnect all the consumers from the
generator with the exception of the battery.
10.2

Connecting the generator

A
NOTICE!
• Connect a relay or a switch to the vehicle's electrical system so that
the generator is not damaged when the power supply is switched
on.
• Connect the generator so that it takes priority over the power supply.
➤ Connect the generator in accordance with the circuit diagrams (fig. a, page 7)
and (fig. b, page 8).
Key for circuit diagram (fig. a, page 7)
Item Description
1 Battery positive terminal
2 Battery negative terminal
3 Battery charger connection
4 Fuel gauge connection
EN
Connecting the electrical power to the generator
19