Lamps Wiring; Final Adjustments - golmar VistaPlus Manuel D'installation

DOOR PANEL INSTALLATION
L
amps wiring.
Once the nameplate labels are placed, wire the lamps
from different modules and connect them to terminals
L1 and L2 of the sound module
If the number of door panel lamps is higher than 6,
connect a TF-104 transformer between ~1 and ~2
terminals of the sound module and change JP2 jumper
position .
NOTE: Don't change JP1 jumper position JP1 and JP2 jumpers are placed
on the left side of the sound module terminal connection block
If the TF-104 transformer with alternating current lock release is also used, wire
~1/~2 terminals of the sound module with CV1/CV2 terminals respectively of the
EL-500/R5 module.
F
inal adjustments.
If after starting the system it's considered that the audio
volume isn't correct, proceed with the necessary
adjustments as shown
The telecamera has a pan and tilt mechanism
If the orientation is not adequate then correct its
position .
In case of low light conditions, an external illumination
can be activated by connecting a SAR-12/24 relay
between terminals '+H' and 'L2' of the sound module
The power to the SAR-12/24 relay must not
IMPORTANT:
exceed 1,8A to 30Vdc/250 Vac
See document TSAR-12/24 for its connection and characteristics.
C
lose the door panel
Fix the door panel by using the supplied screws and washers
Finish the door panel assembly by pressing the closing heads
If it were necessary to open the door panel once closed, use a
plain screwdriver to remove the closing heads
.
.
.
.
.
.
.
.
.
.
109
.