End Of Line Resistor - golmar VistaPlus Manuel D'installation

112
D
escription of the identification label
.xx
H
andling the end of line
*
Factory Default
Example configuration of the end of line
jumper in Tekna R5 colour monitors For
more details, see installation diagrams on
pages 125 to 141.
.
For an easiest repair, replacement or increasement
MASTER:
SLAVE:
00000000000
INTER: N
A1: N
CODE:
STAIR
jumper.
The end of line jumper is situated on the CN2 connector, which is
found on the back of the monitor. It has three positions
*
Set to the centre position when there are no
parallel monitors
If there is a parallel monitor, set to this position on
the first monitor Deactivated mode
If there is a parallel monitor, set to this position on
the last monitor Activated mode
.
MONITOR DESCRIPTION
of the existing monitors, fill the identifying label
information .
master monitor .
slave monitor .
ot used .
ot used .
push button code (page 107
: Not used.
. (Automatic mode)
. (
. (
End of line
End of line
resistor installed
resistor removed
).
:
)
)
End of
line jumper
Distributor