Monitor Installation - golmar VistaPlus Manuel D'installation

114
F
ix the monitor connection block to the wall.
Avoid placing the monitor near sources of heat, in
dusty locations or smoky environments.
To install the monitor directly over the wall, drill two
holes of Ø6mm and use the supplied screws.
The upper part of the monitor connection block must
be placed at 1.60m height. The minimum distance
between the monitor connection block and th
closest object must be 5cm.
F
ix the monitor.
MONITOR
e
Place the monitor at right angles to the
connection block and align the attaching
holes of the monitor with the attachment
hooks of the connection block, as it is
shown on the drawing.
Lock out the monitor. Press the right side till
the attachment clip locks the monitor firmly.
To disassemble the monitor from the connector,
use a plain screwdriver to release the attachment
clip. Remove the monitor from the connection
block, with special attention do not falls.
INSTALLATION