About This Document; General Safety Precautions - STEINEL LS 150 S Mode D'emploi

GB

1. About this document

– Under copyright. Reproduction either in whole or
in part only with our consent.
– Subject to change in the interest of technical
progress.

2. General safety precautions

Failure to observe these operating
!
instructions presents hazards!
These instructions contain important information on
the safe use of this product. Particular attention is
drawn to potential hazards. Failure to observe this
information may lead to death or serious injuries.
• Read instructions carefully.
• Follow safety advice.
• Keep instructions within easy reach.
– Working with electrical current may produce haz-
ardous situations. Touching live parts can result
in electrical shock, burns or death.
– Work on mains voltage must only be performed
by qualified, skilled personnel.
– National wiring regulations and electrical
operating conditions must be observed (e.g.
D: VDE 0100, A: ÖVE-ÖNORM E8001-1,
CH: SEV 1000).
– Only use genuine replacement parts.
– The floodlight enclosure heats up when the
light is on. Only align the LED panel once it has
cooled down.
– Repairs must be made by specialist workshops.
3. LS 150 S / LS 150
Proper use
LS 150 S
– Sensor-switched LED floodlight with infrared
motion detector.
– For indoor and outdoor wall mounting
LS 150
– LED floodlight.
– For indoor and outdoor wall mounting
Non-intended use
– The LED floodlight cannot be dimmed.
Not dimmable
Features
– Tilting and turning LED panel.
– Moveable sensor housing (S only) (± 80°)
– Operation via control dial (S only).
– Infrared motion detector (S only).
Operating principle
– Wide-area lighting from efficient LED technology
in combination with the opal panel.
LS 150 S only:
– The integrated infrared sensor detects the heat
radiated from moving objects (e.g. people,
animals).
– The heat detected in this way is converted elec-
tronically into a signal that automatically switches
ON a connected load (e.g. a light).
– The most reliable way of detecting motion is to
install the unit with the sensor aimed across the
direction in which a person would walk.
– Reach is restricted when the unit is approached
head on.
– Obstacles (e.g. trees, walls etc.) interrupt the line
of sensor vision.
– Heat radiation is not detected through obstacles
(e.g. walls or panes of glass), the sensor is not
triggered.
– Sudden fluctuations in the temperature from
changes in weather are not distinguished sourc-
es of heat.
Models
– LS 150 S
– LS 150
Package contents (Fig. 3.1, 3.2)
Floodlight adjustment range (Fig. 3.3, 3.4, 6.7)
Sensor unit swivelling range (Fig. 3.3, 6.6)
LS 150 S product dimensions (Fig. 3.5)
LS 150 product dimensions (Fig. 3.6)
LS 150 S product components (Fig. 3.7)
A LED panel
B Enclosure
C Wall mount
D Time setting
E Twilight setting
F Sensor unit
G Ring cover
– 13 –
GB