Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
7
Operation
7.1
Switching the product on and off
1. Press the function key to switch on the display of the control unit.
- The control unit automatically switches off approximately 2
after the last time a key was pressed. The display shows OFF.
7.2
Display formats
Keep pressing the function key to select one of the four available units for the
level:
•
Indication of volume in litres
- The arrow at the bottom of the display points to Litres
•
Indication of volume in m³
- The arrow at the bottom of the display points to m³
•
Indication of volume in percent of total contents
- The arrow at the bottom of the display points to %
•
Indication of liquid level in mm
- The arrow at the bottom of the display points to FH
7.3
Correcting the adjusted tank data
If the measured value exceeds the set tank data (for example, because the
tank data is incorrect), the display starts to flash. The display toggles
between the displayed value and "----".
- Only the current liquid level in mm is displayed permanently.
1. Simultaneously press and hold down the two programming keys for a
period of three seconds to activate the "Enter Tank Data" mode.
- The upper left corner of the display shows the arrows.
2. Correct the tank data (see chapter "Determining the tank data").
- If you do not want to change any of the tank data, press the function key
four times to return to the measuring mode.
- The arrows are no longer displayed in the top left corner of the display.
Operation
EN
1
minutes
/
2
23
DIT 10
Publicité
Table des Matières
