ESAB ESP-150 Manuel D'instruction page 141

SECTION 3
* NOTE: If CNC does not have a nor-
mally closed emergency stop
switch, a jumper must be installed
between TB1-16 and TB1-20.
6.
Control Mode Selection for Operation with Remote Plumbing Box
The ESP-150 is supplied from the factory with Plug P45 connected to the J4 (MAN)
receptacle (torch gases and torch connected directly to the ESP-150 power source).
If the unit is to be used with a remote plumbing box, move P45 to the J5 (MECH)
receptacle.
Factory supplied for standard
operation - P45 to J4 (MAN)
Figure 8. Manual vs. Mechanized Operation
Figure 9. J1 Remote Control
Receptacle Pin Configuration for CNC Connection
135
INSTALLATION
P45 moved to the J5 (MECH)
position to allow use of
remote plumbing box
J1
CONNECTOR
Note: J1 Mating Plug and Clamp
USER SUPPLIED CABLE
14-PIN Straight
*
Connector ...................... 636667
Clamp ........................... 6271127