Thermador ME301YP Guide D'utilisation Et D'entretien page 32

en-us Eliminating faults
Fault
"E" and a number appears in display and
control beeps
With a new oven there is a strong odor
when oven is turned on
Control does not react when a key is
touched
Warm air or steam escapes from oven vent It is normal to see or feel steam or warm air
Cooling fan runs even when the oven is
turned off
32
Cause
An electronics fault has occured
This is normal with a new oven and will dis-
appear after a few uses
The control is wet or soiled
The buttons are not pressed correctly
escaping from the oven vent
The cooling fan will continue to run, even
after the oven has been turned off, until the
oven has cooled sufficiently
Troubleshooting
Press any key to stop the beeping.
1.
Reset the oven if necessary.
2.
Call an authorized service provider.
3.
▶ Operate the self clean mode to burn-off the smell more
quickly.
▶ Clean the control panel an wipe it dry.
Press the center of the button.
1.
Use the flat part of your finger.
2.
CAUTION
Risk of fire!
The oven vents are important for air circula-
tion. Covering the oven vents will cause the
oven to overheat. Refer to the appliance over-
view for the location of the oven vents.
→ "Familiarizing yourself with your appliance",
Page 11
▶ Do not obstruct oven vents.
▶ This is normal. There is no action required.