Installation Conditions; Installation; Installation Check - Endress+Hauser iTEMP HART TMT142 Manuel De Mise En Service

Installation

54
3.2

Installation conditions

3.2.1 Dimensions
The dimensions of the device can be found in chapter 10 ''Technical data".
3.2.2 Installation point
Information on installation conditions, such as ambient temperature, protection classification,
climatic class etc., can be found in chapter 10 "Technical data".
3.3 Installation
3.3.1 Direct wall mounting
Proceed as follows to mount the device directly on wall:
• Drill 2 holes
• Attach the device to the wall with 2 screws (M6).
3.3.2 Pipe installation
The mounting bracket is suited for pipes with a diameter between 1.5" - 3.3".
Proceed as follows to mount the device on a pipe:
• Attach the mounting bracket to the pipe
• The additional mounting plate must be used for pipes with a diameter of 1.5" to 2.2".
• Fix the device to the mounting bracket with the two screws supplied. The mounting plate is not
needed for pipes with a diameter of 2.2" - 3.3".
Fig. 4: Mounting the field transmitter with the mounting bracket, see 'Accessories' section
3.4

Installation check

After installing the device, always run the following final checks:
Device condition and specification
Is the device visibly damaged (visual check)?
Does the device comply to the measurement point specifications, such as
ambient temperature, measurement range etc.?
TMT142
Hint
-
See chapter 10 "Technical data"
Endress+Hauser