Exchanging The Light Bulb; Transport And Changing The Location - Medion MD 2867 Mode D'emploi

out of the power socket. Leave the door open during
the defrosting process.
Place one or more bowls with hot, not
boiling, water into the freezer compart-
ment to accelerate the defrosting process.
Thoroughly dry the freezer compartment and set the
thermostat to the position MAX.
Do not use any electrical equipment, e.g. hot air
blowers or hair dryers, to accelerate the defrosting
process.

Exchanging the light bulb

If you need to exchange the light bulb in the
refrigerator compartment, then proceed as follows:
1. Pull the plug out of the power socket
2. Remove the lamp cover by pressing the hooks on
the sides.
3. Exchange the defect bulb with a new one
(max. 15 W)
4. Replace the lamp cover and wait 5 minutes
before you switch on the unit again.

Transport and changing the location

Please observe the transport specifications on the
packaging box.
Before transporting, remove all movable parts out of
the unit or fasten them with adhesive tape.
Defrosting
GB
GB-19