Elica NikolaTesla One BL/A/83 Prescriptions De Montage Et Mode D'emploi page 81

Automatic hood mode with SNAP®
For information on how to make the connection between the
hood and SNAP®, see the manual supplied with SNAP® or
visit www.elica.com.
Note: SNAP® is an auxiliary extraction unit able to operate at
the same time as the hood.
To activate this function:
Briefly press (7) , the LED "
"SNAP" (21) will light up to indicate that the hood is working in
this mode.
" (18) and the LED
The device can also be used in combination with a
Window sensor KIT (not supplied by the manufacturer).
If the Window sensor KIT is installed (only in the case of use
in EXTRACTOR mode), air extraction will halt every time the
window in the room, on which the KIT is applied, is closed.
- The KIT must be electrically connected to the device
by qualified and specialised technical personnel.
- The KIT must be certified separately in accordance
with the safety standards for the component and its
use with the device. Installation must be carried out
in accordance with current regulations for domestic
systems.
PLEASE NOTE:
- the wiring of the KIT to be connected to the device
must be part of a certified safety extra-low voltage
(SELV) circuit.
- the manufacturer of this device declines all liability
for any inconvenience, damage or fires caused by
defects and/or problems associated with the
malfunction and/or incorrect installation of the KIT.
81