Elica NikolaTesla One BL/A/83 Prescriptions De Montage Et Mode D'emploi page 75

3.3 Mounting
Before starting the installation:
• After unpacking the product, check that it has not
been damaged during transport and in the event of
problem, please contact the reseller or the Customer
support service before installing it.
• Check that the product is the right size for the installation
area.
• Check for accessories (e.g. bags containing screws,
warranty certificates, etc.) inside the packaging (placed
there for transport reasons). Remove and keep them
safe, if present.
• Also check that there is a power socket near the
installation area.
Preparing the cabinet for installation:
- The product cannot be installed above cooling appliances,
dishwashers, heaters, ovens, washing machines and
dryers.
- Create the cut-outs in the cabinet before inserting the hob
and carefully remove any shavings or sawdust.
IMPORTANT: use a single-component adhesive sealant (S),
which withstands temperatures up to 250°; before
installation, thoroughly clean the surfaces to stick and
eliminate any substance that may compromise adhesion,
(e.g. release agents, preservatives, fats, oil, dust, traces
of old adhesives, etc.); the adhesive should be uniformly
spread all around the outside of the frame; after sticking,
leave the adhesive to dry for about 24 hours.
Fig. 1b
Caution! Failure to install screws and
fasteners in accordance with these
instructions may result in electrical
hazards.
Note: to ensure the correct installation of the product, it is
recommended to tape the pipes using an adhesive with the
following characteristics:
- soft elastic PVC film, with an acrylic-based adhesive
- compliant with DIN EN 60454 regulations
- flame retardant
- excellent resistance to wear
- resistant to temperature fluctuations
- can be used at low temperatures
75