LG LDE3037ST Manuel Du Propriétaire page 42

Problem
Food does not broil • Aluminum foil used on the broiling pan and grid has not been fitted properly and slit as
properly recommended.
- See the Using the Oven section.
• In some areas the power voltage may be low.
- Preheat the broil element for 5-7 minutes
- See the Broiling Guide.
Oven temperature too • Oven sensor needs to be adjusted.
hot or too cold - See the adjusting your oven Temperature in option section.
Scratches or abrasions • Coarse particles such as salt or sand between cooktop and utensils can cause scratches.
on cooktop surface Be sure the cooktop surface and bottoms of utensils are clean before usage. Small scratches
do not affect cooking and will become less visible with time.
• Cleaning materials not recommended for ceramic-glass cooktop have been used.
See Cleaning the Glass Cooktop in the MAINTENANCE section.
• Cookware with rough bottom has been used. Use smooth, flat-bottomed cookware.
Metal marks • Scraping of metal utensils on cooktop surface. Do not slide metal utensils on cooktop
surface. Use a ceramic-glass cooktop cleaning creme to remove the marks.
See Cleaning the Glass Cooktop in the MAINTENANCE section.
Brown streaks or specks • Boilovers are cooked onto surface. Use the blade scraper to remove soil.
See Cleaning the Glass Cooktop in the MAINTAINANCE section.
Areas of discoloration • Mineral deposits from water and food. Remove using a ceramic-glass cooktop cleaning
on cooktop. creme. Use cookware with clean, dry bottoms.
Oven will not self clean • The oven temperature is too high to set a self clean operation.
- Allow the range to cool and reset the controls.
• Oven controls improperly set.
- See the Self Clean section.
• A self clean cycle cannot be started if the oven lockout feature is active.
"Crackling" or "popping" • This is the sound of the metal heating and cooling during both the cooking and Self Clean
sound functions.
- This is normal.
Fan noise • A convection fan may automatically turn on and off.
- This is normal.
Oven racks are difficult • Apply a small amount of vegetable oil to a paper towel and wipe the edges of the oven
to slide racks with the paper towel.
Convection Fan stops • Convection fan stops during a convection bake cycle.
- This is normal and is done to allow for more even heating during the cycle.
Displayed Time is • This is normal. This means that the product has just been plugged in, or that it has
flashing experienced a power interruption. Press the Clock key and reset the time, or press any key
to stop the flashing.
This is not a failure of the range and should be considered normal operation.
Possible Causes / Solutions
41
TROUBLESHOOTING