Using The Cooktop; Cooking Areas; Hot Surface Indicator; Using The Cooktop Elements - LG LDE3037ST Manuel Du Propriétaire

USING THE COOKTOP

COOKING AREAS

The cooking areas on your range are identified by
permanent circles on the glass cooktop surface. For the
most efficient cooking, fit the pan size to the element
size.
Pans should not extend more than 1/2 to 1-inch
beyond the cooking area.
When a control is turned on, a glow can be seen through
the glass cooktop surface. The element will cycle on and
off to maintain the preset heat setting, even on Hi.
For model : LDE3037
WARM
SINGLE
ZONE
DUAL
For Model : LDE3031
SINGLE
SINGLE
SINGLE
DUAL
SINGLE
SINGLE
USING THE COOKTOP

Hot surface indicator

HS (Hot Surface) will appear in the display once the
element is turned off or during the self clean cycle. The
HS indicator will stay on until the surface has cooled to
approximately 150°F (66°C) or when the self clean cycle
ends.
CAUTION
It is normal for the surface elements to cycle on and
off during cooking, even at higher settings. This
will happen more frequently if cooking on a lower
temperature setting.

USING THE COOKTOP ELEMENTS

To turn on a SINGLE element
SINGLE
1. Press the ON/OFF button that controls the element
that you would like to use.
2. Press the + button once to adjust the element
temperature to Hi, or the – button once to adjust the
element temperature to Lo.
3. Use the – / + buttons to adjust the element
temperature settings. The element temperature
settings are adjustable at all times.
4. To turn off the element after cooking, press the ON/
OFF button once.
NOTE
• Hi is the highest temperature available.
• Lo is the lowest temperature available.
• Press and hold the + or – buttons to quickly scroll
through the temperature settings.
17