Working With The Machine - Festool TS 75 EBQ Notice D'utilisation D'origine

English
6.6 Extraction
WARNING
Health risk due to dust
► Always work with an extractor.
► Comply with national regulations.
A Festool mobile dust extractor with an extrac­
tor hose diameter of 27 mm or 36 mm (36 mm
recommended due to the reduced risk of clog­
ging) can be connected to the extractor connec­
tor [6-1].
6.7 Installing the splinter guard
With 0° cuts, the splinter guard (accessory) sig­
nificantly improves the quality of the cutting
edge of the sawn-off workpiece on the upper
side.
► Place the splinter guard [5-1] onto the pro­
tective cover,
► Position the machine on the workpiece/
guide rail,
► Push down on the splinter guard until it
makes contact with the workpiece and
tighten it using the rotary knob [5-2],
► Saw in the splinter guard (machine at maxi­
mum cutting depth and speed level 6).
7

Working with the machine

When working on the machine, observe
all of the initial safety notes and the fol­
lowing rules:
– Only guide the power tool towards the
workpiece when it is switched on.
– Check the mounting fixture prior to use and
do not use the machine if it does not work
correctly.
– Always secure the workpiece in such a way
that it cannot move during machining.
– When working, always hold the power tool
with both hands on the handles [1-1, 1-6].
This reduces the risk of injury and is a pre­
requisite for precise work.
– Always push the saw forwards[1-2], and
never towards yourself.
– Adapt the infeed speed to prevent the cut­
ters on the saw blade from overheating and
20
prevent plastic materials from melting dur­
ing cutting.
– Make sure that all rotary knobs [3-4, 3-6]
are tightened before starting work.
– Do not work with the machine if the elec­
tronics are defective, because this may lead
to excessive speeds. You can tell if the
electronics are defective if there is no
smooth start-up or if it is not possible to
regulate the speed.
When carrying out work that produces
dust, wear a breathing mask.
7.1 Sawing along the scribe mark
The gauge marker [6-3] displays the cutting
line for 0° and 45° cuts (without a guide rail).
7.2 Cutting sections
Position the machine with the front part of the
saw table on the workpiece, switch on the ma­
chine, push it down to the set cutting depth and
push it forward in the cutting direction.
7.3 Sawing cut-outs (plunge cuts)
In order to avoid kickbacks, the following
instructions must always be followed
when plunge cutting:
– Always position the machine with the rear
edge of the saw table against a fixed stop.
When working with the guide rail, position
the machine at the kickback stop [7-1],
which is clamped to the guide rail (see
Fig. [7]; when not in use, the kickback stop
can be stored by the guide plate [7-2] of the
machine).
– Always hold the machine securely using
both hands and plunge slowly.
Procedure
Position the machine on the workpiece and
place it against a stop (kickback stop), switch on
the machine, slowly push it down to the set cut­
ting depth and push it in the cutting direction.
The marks [6-2] indicate the absolute front and
rear cutting points of the saw blade (210 mm di­
ameter) when using the saw at maximum cut­
ting depth with the guide rail.