Overheating Protection; Emptying The Waste Bins - Olympia PS 950 CCD Mode D'emploi

To shred CDs, only insert one CD at a time using a little force to feed them
into the slot at the front. The CD is then drawn in automatically and
shredded. To shred credit cards, feed them long side first into the CD and
credit card slot.
Switch position OFF:
When the switch is in this position, the device is switched off.
Switch position REV (reverse):
This switch position serves to clear up paper jams, should they occur. The
cutting mechanism runs backwards and the paper is fed back out of the paper
infeed.

Overheating protection

The device is not designed for continuous operation (max. operating time of
5 minutes followed by a pause of 20 minutes). In the event of the motor
overheating, a motor circuit breaker automatically switches the motor off.
Example:
1. You use the shredder uninterrupted for over 5 minutes and at the
maximum capacity of 12 sheets.
2. You exceed the shredder's load limit by inserting more than
12 sheets or not feeding the paper straight and flat, for example.
After the overheating protection has been triggered, let the shredder cool
down for at least 20 minutes. Disconnect the power plug in this case.

Emptying the waste bins

Empty the waste bins regularly to prevent the cuttings overflowing and
possibly causing damage to the device.
1. Switch the device off.
2. Pull the waste bins out of the device. Empty the CD and credit card
bin and the waste paper bin.
20