Switching The Device Off; Motor Protection; Clearing Paper Jams - Olympia PS 16 Mode D'emploi

5.3 Feeding in paper or credit cards
Note! A maximum of 6 sheets of A4 paper with a weight of maximally 80 g/m² may
be inserted in the paper infeed at a time.
1. The shredder is connected to the mains power outlet and the sliding switch is set to
Auto.
2. The paper must be straight when inserted in the paper infeed. Feed credit cards in
between the two arrows.
Note! Ensure that the sliding switch is set to Off after the shredding operation has been
completed.

5.4 Switching the device off

•
Disconnect the power plug from the power socket.
6.

Motor Protection

The motor switches off automatically in the event of an overload. First of all, disconnect
the power plug from the power socket and allow the motor to cool down to room temper-
ature. Then connect the power plug to the power socket again and continue operation.
Note! Observe the continuous operation time stipulated in Chapter "Technical Data".
7.

Clearing Paper Jams

If too much paper is fed into the cutting mechanism, a paper jam occurs. The shredder
switches off automatically in the event of a paper jam.
Proceed as follows:
1. Press the Rev button to activate reverse operation and feed the paper back out.
2. Remove any residual paper from the infeed in forward feed (Auto).
Note! Wenn durch den Rückwärts-/Vorwärtslauf die Blockade nicht beseitigt wurde,
ziehen Sie den Netzstecker und entfernen Sie danach die Papierreste manuell aus dem
Schneidwerk.
3. Set the sliding switch to Auto.
4. Reduce the quantity of paper being shred and continue with the shredding process.
7.1 Rev setting (reverse operation)
Set the sliding switch to Rev so that the cutting mechanism runs in reverse and releases
the paper.
7.2 Forward feed (Auto)
Set the sliding switch to Auto in order to ensure any residual paper is shredded and
removed from the cutting mechanism.
20
G