Preparation; Clearances; Location; Moving And Vacation - GE 21 Guide D'utilisation Et D'entretien

Preparing for Vacation
For shorter vacations, remove perishable foods and leave controls at
regular settings. However, if room temperature is expected to drop
below 60°F. (16°C.), follow same instructions as for extended
vacations.
For extended vacations or absences, shut off power to refrigerator,
move the freezer control to OFF position, and clean interior with
baking soda solution of 1 tablespoon (15 ml) of soda to 1 quart (1 L)
of water. Wipe dry. To prevent odors, leave open box of soda in
refrigerator. Leave doors open.
Move icemaker feeler arm to STOP (up) position and be sure to shut
off water supply to the refrigerator.
Refrigerator Location
Do not install refrigerator where temperature will be below 60°F.
(16°C.) because it will not run often enough to maintain proper
temperatures.
Do install it on a floor strong enough to support a fully loaded
refrigerator.
Rollers
Adjustable rollers behind the base grille enable you to move the
refrigerator away from the wall for cleaning. These rollers should be
set so the refrigerator rests firmly on the floor. Side-by-side
refrigerators also have specially
designed door hinges that lift both
doors slightly when opened, allowing
the force of gravity to help close
them securely.

Water Supply to Icemaker

You will need to connect your icemaker to a cold water line. A water supply kit containing copper
tubing, shut-off valve, fittings and instructions is available at extra cost from your dealer. There
should be sufficient tubing for the icemaker from the cold water supply to allow you to move the
refrigerator out from the wall several feet (approximately 4 feet [1.25 m] of 1/4" copper tubing
coiled into one big loop).
12

PREPARATION

Preparing to Move
Disconnect power cord from wall outlet, remove all food, and clean
and dry the interior.
Secure all loose items such as grille, shelves and storage pans by
taping them securely in place to prevent damage.
Be sure refrigerator stays in upright position during actual moving and
in van. Refrigerator must be secured in van to prevent movement.
Protect outside of refrigerator with blanket.

Clearances

Allow the following clearances for ease of installation, proper air
circulation, plumbing and electrical connections.
Sides .........5/8" (15 mm)
Top .........1" (25 mm)
Back .........1/2" (13 mm)
(If built-in, allow 7⁄8 " [22 mm] for hinge covers.)
If the refrigerator is against a wall on either side, allow 3/4" (19 mm)
for door clearance.
Leveling
To adjust rollers, remove the base grille by grasping it at the bottom
and pulling it out.
Turn front roller adjusting screws clockwise to raise the
refrigerator, counterclockwise to lower it. Use an adjustable wrench
(3/8" hex head bolt) or pliers.
Turn the rear roller adjusting screws clockwise to raise the
refrigerator, counterclockwise to lower it. Use a flat blade screwdriver.
NOTE: When leveling, you can improve door closure by raising the
front as much as 5/8" (15 mm) more than the rear of the refrigerator.
To replace base grille, align prongs on back of grille with clamps in
cabinet and push forward until grille snaps into place.
Slot where prong of
Front roller
grille snaps into place
adjusting screw
Rear roller
adjustment
screw