Technical Data - Ingersoll Rand ENL 2 Instructions De Montage Et De Service

min./max. operating pressure
(see type plate)
min./max. temperature
(see type plate)
Condensate inflow
Condensate outflow
Condensate
Housing
Weight (empty)
This product has been tested to the requirements of CAN/CSA-C22.2 No. 61010-1-12, third edition, including
a later version of the same standard incorporation the same level of testing requirements.
Peak compressor performance
Peak refrig. dryer performance
(only with pre-separation)
Peak filter performance
(behind dryer)
Supply voltage
(see type plate)
Power consumption
Recommended
cable-jacket diameter
Recommended
wire cross-section
Spring-loaded terminal
Recommended
wire cross-section
Screw terminal
Recommended
stripping of cable jacket
Recommended
length of the wire end tube
Spring-loaded terminal
Recommended
length of the wire end tube
Screw terminal
Protection class
Overvoltage category
(IEC 61010-1)
VAC = V alternating current
VDC = V direct current
80442866

5. TEChNICAL DATA

0,8...16 bar (12...20 psi)
or
1,2...16 bar (17...20 psi)
+1...+60 °C (+4...+140 °F)
or
+1...+70 °C (+4...+18 °F)
NPT ½ (½") internal
max. screw-in depth 1, mm (½")
G ¼ (¼") Ø 8 ... 10 mm hose connector
oil-contaminated + oil-free
aluminium + plastic, glass fibre-reinforced
0,8 kg (1.8 lbs)
100 scfm
200 scfm
1000 scfm
9...240 VAC ±10% (0...60 Hz) /100...12 VDC ±10%
or
24...48 VAC ±10% (0...60 Hz) / 18...72 VDC ±10%
P = 0,6 ...  VA (W)
Ø ,0...10 mm (0,20"...0,9")
0,7...1, mm² (AWG 16...20)
0,7...2, mm² (AWG 14...20)
~ 0 mm (~ 1.97")
~ 8 mm (~ 0.1 inch)
~ 6 mm (~ 0.24 inch)
IP 67
II
ingersollrandproducts.com
EN