Care And Maintenance - LawnMaster CS1216 Manuel D'utilisation

MAINTENANCE

CARE AND MAINTENANCE

Check the drive sprocket (19). If it is worn or damaged due to strain, have it replaced by an
authorised service agent.
Clear residue from the rails on the guide bar (6) using a screwdriver, putty knife, wire brush or other
similar tool. This will keep the oil passages open to provide proper lubrication to the bar (6) and
chain (5) .
Check the guide bar 'rail' for wear: Hold a ruler (straight edge) against the side of the guide bar
and 'cutter side plates'. If there is a gap between the ruler and guide bar the guide bar 'rail' is normal.
If there is no gap (ruler flush against the side of the guide bar) the guide bar 'rail' is worn and needs
to be replaced with a new one of the same type .
Turn the guide bar 180° to allow even wear, thereby extending the life span of the guide bar (6).
Loosen the screw and remove the tension disc (6b) from the guide bar.
Ensure the rubber washer on the screw is free of wear. Turn the guide bar and fix the tension disc
with the screw. Apply a drop of suitable glue to the screw to ensure its safe positioning when reassembly.
37