Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
MAINTENANCE
Turn the chain tensioning knob clockwise to tension the chain.
NOTE: A cold chain is correctly tensioned when there is no slack on the underside of the guide bar, the chain
is snug, and it can be turned by hand without binding.
on the drive links hang out of the bar groove.
NOTE: During normal saw operation, the temperature of the chain increases. The drive links of a correctly
tensioned warm chain will hang approximately 1/16" (1.3 mm) out of the bar groove.
NOTE: New chains tend to stretch. Check the chain tension frequently and tension as required.
C A U T I O N
A chain tensioned while warm may be too tight upon cooling.
Check the "cold tension" before next use.
FLATS ON DRIVE LINKS
.050 in.
35
Fig. 38
Fig. 39
Publicité
Table des Matières
