Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
MAINTENANCE
CUTTERS
CHAIN DRIVE LINKS
CHAIN DRIVE LINKS
Release the tip of the guide bar, and turn the chain tensioning knob 1/2 turn clockwise.
Hold the tip of the guide bar up and tighten the chain cover lock knob.
The chain is correctly tensioned when there is no sag on the underside of the guide bar, and
when the chain is snug, but can be turned by hand without binding.
NOTE: If chain is too tight, it will not rotate. Loosen the chain cover lock knob slightly, and turn the chain
tensioning knob 1/4 turn counter-clockwise. Lift the tip of the guide bar up, and retighten the chain cover lock
knob. Ensure that the chain will rotate without binding.
W A R N I N G
Never touch or adjust the chain while the motor is running. The saw chain is very sharp. Always
wear protective gloves when performing maintenance involving the chain.
CHAIN ROTATION
GROOVE
Fig. 34
BAR
Fig. 35
34
Fig. 36
Fig. 37
Publicité
Table des Matières
