General Cleaning - LawnMaster CS1216 Manuel D'utilisation

MAINTENANCE
Switch the product off, remove the battery pack and let it cool down
Check, clean and store the product as described below
Keep the product clean. Remove debris from it after each use and before storage.
Regular and proper cleaning will help ensure safe use and prolong the life of the product.
Inspect the product before each use for worn and damaged parts.
Do not operate it if you find broken and worn parts.

GENERAL CLEANING

Clean the product with a slightly damp cloth and mild soap. Use a brush for areas that are hard to reach.
In particular clean the air vents (4) after every use with a cloth and brush.
Remove stubborn dirt with high pressure air (max. 3 bar).
Check for any damage and wear. Repair damages in accordance with this instruction manual or
take it to an authorised service centre before using the product again.
SPROCKET NOSE
Clean the sprocket nose (7). Using a disposable lube gun, insert
the needle nose into the lubrication hole (C) and inject grease until
it appears at the outside edge of the sprocket (Fig. 23).
Rotate the saw chain (5) by hand. Repeat the lubrication procedure
until the entire sprocket has been greased.
GUIDE BAR AND SAW CHAIN MAINTENANCE
Most guide bar problems can be prevented merely by keeping the product well maintained.
Incorrect filing and non-standard cutter and depth gauge settings are the causes of most guide
bar problems, primarily resulting in uneven bar wear. As the bar wears unevenly, the rails widen,
which may cause the chain to clatter and make it difficult to complete straight cuts. If the guide bar
is insufficiently lubricated and the product is operated with a saw chain which is too tight, this will
contribute to rapid bar wear. To help minimise bar wear, maintenance of the guide bar as well as
the saw chain is recommended.
Disassemble the guide bar and saw chain in >>reversed order from assembly.
Check the oiling port (16) for clogging and clean >>if necessary to ensure proper lubrication of the
guide bar and saw chain during operation. Use a soft wire small enough to insert into the oil
discharge hole
29
C
Fig.23