Applications - LawnMaster CS1216 Manuel D'utilisation

OPERATION
W A R N I N G
Do not allow familiarity with this product to make you careless. Remember that a careless fraction
W A R N I N G
Always wear safety goggles or safety glasses with side shields when operating power tools. Failure
to do so could result in objects being thrown into your eyes, resulting in possible serious injury.
W A R N I N G
Do not use any attachments or accessories not recommended by the manufacturer of this product.
The use of attachments or accessories not recommended can result in serious personal injury.

APPLICATIONS

You can use this product for the purposes listed below:
Basic limbing, felling, and woodcutting
Removing buttress roots
ADDING BAR AND CHAIN LUBRICANT (See Fig. 6)
Use standard chainsaw bar and chain Lubricant. It is designed for chains and chain oilers, and is
formulated to perform over a wide temperature range with no dilution required.
NOTE: The chainsaw comes from the factory with no bar and chain oil added. Level should
also be checked after every 20 minutes of use, and refilled as needed.
Remove oil cap.
Carefully pour the bar and chain oil into the tank.
Wipe off excess oil.
Repeat as needed.
NOTE: Do not use dirty, used or otherwise contaminated oils. Damage may occur to the bar or chain.
NOTE: It is normal for oil to seep from the saw when not in use. To prevent seepage, empty the oil
tank after each use, then run for one minute. When storing the unit for a long period of time (three
months or longer), be sure the chain is lightly lubricated. This will prevent rust on the chain and bar
sprocket.
15