MAINTENANCE
SAW CHAIN TENSIONING
Always check the saw chain tension before use and regularly during use approx. every five cuts.
Upon initial operation, new chains can lengthen considerably. This is normal during the break-in
period and the interval between future adjustments will lengthen quickly.
SET THE PRODUCT ON A SUITABLE FLAT SURFACE.
Turn the tension wheel (8) until the chain "tie straps" are just touching the bottom edge of the
guide bar (6) (Fig. 26).
8
6
Fig. 26
TENSION TEST
Check the chain tension using one hand to lift the saw chain (5) against the weight of the product.
The correct chain tension is achieved when the saw chain can be lifted by approximately 2 - 4 mm
from the guide bar (6) in the centre (Figs. 27-28).
Adjust the tension if you find that the chain saw is too loose or tight
Fig. 27
Fig. 28
32