TAKATA MINI I-SIZE Manuel D'utilisation page 75

Step 5 – Adjust the carry handle
[MINI_I-SIZE_053] Simultaneously push in the grey
levers on each side of the handle as far as they can go,
and move the carry handle forward into the vehicle
position (centre position).
CAUTION!
Whenever you change the position of the carry handle,
always check that it is locked into place. To do this,
lightly push the handle back and forwards with your
hand, without pressing down on the levers.
Step 6 – Fasten the vehicle shoulder belt
[MINI_I-SIZE_053] Bring the vehicle's shoulder belt
around to the back of the TAKATA MINI I-SIZE.
Position it as shown in the illustration.
CAUTION!
On the side with the seatbelt buckle, the shoulder
belt must run beneath the shoulder belt guide of the
TAKATA MINI I-SIZE. On the other side, where the
seatbelt rises to the upper attachment point in the
vehicle, the belt must run through the other shoulder
belt guide.
Step 7 – Tighten the vehicle lap belt
[MINI_I-SIZE_054] To tighten the vehicle lap belt,
pull the shoulder section of the seatbelt directly above
WKH EXFNOH XQWLO WKH ODS EHOW VHFWLRQ LV VXI¿FLHQWO\
tight.
Ensure that the lap belt is in no way twisted.
Step 8 – Tighten the vehicle shoulder belt
[MINI_I-SIZE_054] Tighten the seatbelt, by pulling
the shoulder section towards the upper attachment point
in the vehicle.
Step 9 – Check the positioning
(QVXUH WKDW WKH UHG OLQH RQ WKH VWLFNHU DI¿[HG WR WKH
de
en
fr
it
es
nl
71