TAKATA MINI I-SIZE Manuel D'utilisation page 62

TAKATA I-SIZE BASE
Adjusting the support leg
Step 1 – Fold out the support leg
[MINI_I-SIZE_027 + MINI_I-SIZE_028] Take hold
of the support leg on the underside of the TAKATA
I-SIZE BASE. Push the release slider of the folding
mechanism to the side, pull the support leg out of the
transportation position, and swing it out as far as it
will go. When it reaches full extension, the support leg
is locked into place by a spring in the release slider.
Step 2 – Unlock and adjust the support leg
[MINI_I-SIZE_029] Press the button on the height
adjustment mechanism as far in as possible, and slide
the support leg up or down. When the desired position
is reached, release the button and check that the
support leg is locked in place. This is indicated by a
click, and a green marking on the top of the button.
58
WARNING!
If the support leg is not set at the correct height, there
is a risk of serious injury to the child or other passengers
in the case of an accident.
[MINI_I-SIZE_030] The correct position of the
support leg is set when the support leg of the TAKATA
,6,=( %$6( OLHV FRPSOHWHO\ DQG ÀXVK DJDLQVW WKH
YHKLFOH ÀRRU DQG WKH LQGLFDWRU DW WKH ORZHU HQG RI WKH
support leg is fully showing a green marking.
Step 3 – Fold in and lock the support leg
[MINI_I-SIZE_027 + MINI_I-SIZE_028] To be able
WR IROG LQ WKH VXSSRUW OHJ \RX PXVW ¿UVW SRVLWLRQ LW LQ
the smallest height setting. Push the release slider of the
folding mechanism to the side, and swing the support
leg towards the underside of the base. When the
support leg lies snug against the underside of the
TAKATA I-SIZE BASE, the support leg is locked into
place by a spring in the release slider.