TAKATA MINI I-SIZE Manuel D'utilisation page 68

Securing the TAKATA I-SIZE BASE
Step 1 – Fold out the support leg
Fold out the support leg as explained in Section 3 –
Basic instructions (Adjusting the support leg), and
ensure that it is properly locked in place.
NOTE!
Check the support leg is locked in place by lightly
shaking it with your hand.
Step 2 – Place on the vehicle seat
[MINI_I-SIZE_039] Place the TAKATA I-SIZE BASE
on the seat of the vehicle. Ensure that:
‡ WKH ,62),; FRQQHFWRUV DUH SRLQWLQJ WR WKH EDFN RI
the car seat.
‡ WKH VXSSRUW OHJ LV SRLQWLQJ WR WKH YHKLFOH ÀRRU
64
Step 3 – Pull out the ISOFIX connectors
[MINI_I-SIZE_031] Press in the button on the inner
side of each rear connection arm as far as possible,
and fully extend the connectors. Follow the instruction
in Section 3 – Basic instructions (Adjusting the
ISOFIX connectors).
NOTE!
The connectors have been fully extended when no
¿JXUH LV GLVSOD\HG RQ WKH WRS RI WKH ,62),; FRQQHFWRUV
Step 4 – Connect the ISOFIX system
[MINI_I-SIZE_040] Point the open ISOFIX connectors
on the TAKATA I-SIZE BASE towards the ISOFIX
points of the vehicle. Slide the connectors into the
vehicle's ISOFIX points, until each one clicks into
place, and the green markings are visible on the release
sliders.