General Operation; Listening To The Radio - AEG KRC 4368 DAB+ Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 21
4. Select the desired language with the SKIP + / SKIP – but-
tons. Set it with the SCAN / SELECT button.
NOTE:
The menu is described with the selected language "ENG-
LISH" in the instruction manual.

General operation

Switch the device on/off
Press the button
to turn the device on or off. The time and
the date appear on the display in standby.
NOTE:
The device stores the last operating mode and the volume
setting before it is turned off. When the device is turned
on again, it starts in this operating mode and this volume
setting.
MODE button (13)
For switching between DAB and FM mode.
VOLUME + /VOLUME – buttons (7)
Adjust to your preferred volume level. The higher the vol-
ume, the more blocks are filled in.
Delayed shut-off (SLEEP)
The device automatically switches off when the selected time
is reached.
• Keep the MENU/SLEEP button (6) pressed. "SET SLEEP
TIME SLEEP OFF" appears on the display. Use the
SKIP + / SKIP – buttons (5 / 6) to select the time after which
the unit should switch off. Select from: 15, 30, 45, 60 and
90 minutes.
• The SLEEP OFF setting deactivates this function.
• Confirm your selection with the SCAN / SELECT button
(4).
NOTE:
When the function is activated, an "S" and the remaining
time until power off appear at the top right of the display.

Listening to the radio

Scan FM stations
1. Repeatedly press MODE button (13) until the display
shows "FM".
2. You have two options for tuning a station:
- Press the SKIP + / SKIP – buttons (5 / 6).
- Press the SCAN / SELECT button (4). Depending on
which button you have already pressed (SKIP + or
SKIP –), the unit scans to the next or previous station.
3. If reception is too weak or there is interference, try to
change the position of the cable antenna for better
reception.
KRC4368DAB+_IM
Show FM information
Press the INFO button (11) to show the following information,
if broadcasted by a radio station.
• Radio Text is shown by default on the display. If no
information is available, [No RadioText] appears on the
display.
• The program type (PTY) of the station is displayed (e.g.
Pop music, news etc.). If no PTY is received, [No PTY]
appears on the display.
• Display of the radio frequency.
• Display the time.
• Display the date.
Scan DAB stations
Digital Audio Broadcasting (DAB) is a digital broad casing
standard for terrestrial reception of digital radio. A list of radio
stations which can be received in Germany is available on the
Internet at www.digitalradio.de.
NOTE:
In Germany approx. 70% of the country' s area is covered by
digital radio broadcasts (as of Nov. 2011). In the individual
areas however, coverage and provision vary greatly. If the
DAB stations in your region cannot be received or only with
interferences depending on location, in this case you can
switch to the FM band to receive this station. This is only
possible however if these stations are broadcast via VHF.
Find out more on the internet site of the radio station.
1. Press the MODE button (13) repeatedly until "DAB
MODE" appears on the display.
2. Keep the INFO / MENU button (12) pressed. The display
shows the menu item "FULL SCAN".
3. Press the SCAN button (4). The device then searches for
the radio stations which can be received.
4. You can select the next or the previous station by using
the SKIP + / SKIP – buttons (5 / 6). Confirm your selection
with the SCAN / SELECT button (4).
5. If the reception is too weak and the received station
"motorboats", try to improve the reception by changing
the position of the antenna.
NOTE:
• For optimal DAB reception, we recommend that you
position the cable antenna vertically.
• To manually set a DAB frequency, proceed as described
in the "Settings menu" sections.
Display additional DAB information
In DAB mode, you can display the following additional
information if broadcast by the radio station. To do so, press
the INFO / MENU button (12).
The DLS text is shown on the display by default.
• DLS: Short for Dynamic Label Segment. This involves
complementary data. This content may be e.g. informa-
tion about the station or the music title and artist being
English
43
17.12.15

Publicité

Table des Matières
loading

Table des Matières