Setting Of The Maximum Brightness Of The Individual Leds; Synchronisation With Other Effect Lights Of The Same Build; Display Setting - Renkforce RDM PAR-Spot 6 x 10 W Mode D'emploi

i) Setting of the maximum brightness of the individual LEDs
In this menu, the maximum brightness of the individual LEDs can be set.
• Select the option curr in the menu SEt.
• Set the maximum brightness of the individual colours as follows:
r.000-r.255
G.000-G.255
b.000-b.255
A.000-A.255
u.000-u.255
The brightness set like this is the upper limit with which the respective LEDs can light up in op-
eration.
The settings in the other menus (e.g. in the operating mode with static colour settings) then refer
to this upper limit. I.e. when the max. brightness r.128 is set for red, the setting r.255 in the other
menus is 50 % of the maximum possible brightness of the red LED.
j) Synchronisation with other effect lights of the same build
If you are using several effect lights of the same build in your light show, the settings can be transferred
to other effect lights.
For this, the effect lights must be connected with DMX cables (for connection, see "Setup of a
master-slave chain").
• Select the option SYn in the menu SEt.
• Select YES to transfer the settings of the effect light to all connected effect lights. The display shows
SEnd while the settings are transferred.
• Select no to not perform this operation.
k) Display setting
The display switches off automatically after an adjustable time without any button being pushed. To reac-
tivate it, push any button.
• Select the option Scrn in the menu SEt.
• Set the time after which the display is to switch off with the buttons UP or Down (t010-t030 = 10-30 s).
34
Max. brightness red
Max. brightness green
Max. brightness blue
Max. brightness amber
Max. brightness white