Eco-Mode And Full-Eco-Control - NUK Eco Control Video Display 550VD Mode D'emploi

Indicators
The following information is shown in the
status bar of the parent unit:
Battery power
Battery is full and LED 21 is lit
up green.
Battery is half-full and LED 21
is lit up green.
Battery is almost empty.
Depending on how it is being
used, the device will automati-
cally switch off within the next
15-20 minutes. We therefore
recommend that you connect
the device to mains power in
order to recharge the battery.
LED 21 is lit up green.
Battery symbol flashes red.
This means that the battery is
empty and the device will
switch off within a very short
time. LED 21 flashes and
device emits a warning beep
every 60 seconds. In addition, a
warning appears in the middle
of the screen.
Bars run across the display
LED 21 flashes green:
The device is connected to mains power
and the battery is being recharged.
The animation stops as soon as the battery
is fully charged and LED 21 no longer
flashes.
Parent unit is connected to
mains power, but no battery is
inserted. LED 21 is lit up green.
Notes:
– Charging the battery for the very first
time takes about 10 hours.
– Subsequently recharging the depleted
battery takes about 6 hours.
– With a fully charged battery, you can
operate the parent unit for up to 8
hours.
The time needed to recharge the battery and
the operating time both depend on how
heavily the parent unit is used:
– The battery can normally be recharged
in about 6 hours, but it will take longer
if the device is switched on at the same
time.
– Similarly, the operating time of up to 8
hours will be reduced if you use the
talk-back function or choose a high
volume setting.
– The operating time can be increased, for
example, if audio monitoring is activated
(see "6.9 Switching between audio and
video monitoring" on page 63), if your
baby has a particularly restful sleep, or if
the "LCD Auto Off" option for the screen
is switched on (see "Switching between
audio and
page 63).
4.5 Eco-Mode and
Full-Eco-Control
This baby monitor has an Eco-Mode
function that not only saves power but also
minimises the high-frequency radio waves in
the nursery.
In this mode,
transmission between the baby unit and the
parent unit, although the Full-Eco-Control
function ensures that both units remain
connected the whole time. If the connection
is interrupted
immediately indicated on the parent unit.
The device automatically deactivates Eco-
Mode and transmits sound and video again
as soon as your baby makes a sound that
exceeds your set sound limit (VOX levels 1 -
4).
Activating Eco-Mode
Eco-Mode can only be activated at VOX
levels 1, 2, 3, and 4 (see "6.8 Setting the
VOX sensitivity level" on page 62). Eco-
Mode is activated automatically as soon as
52
video monitoring"
there is only
in Eco-Mode,
on
limited
this is