Setting The Vox Sensitivity Level - NUK Eco Control Video Display 550VD Mode D'emploi

The menu on the parent unit will be
closed and video transmission from the
selected camera/baby unit will be shown.
The number of the active camera/baby
unit is displayed in the status bar and the
PM symbol disappears.
Connection problems in patrol mode
If there is a connection problem with
one of the baby units while the
parent unit is in patrol mode, you will
hear a beep and a corresponding symbol
will appear on the screen.
The units will automatically try to
reconnect, and will continue to
attempt this until the connection is
established successfully once more. Once
the connection has been reestablished
successfully, the device will return directly
to monitoring mode.
If the parent unit continues to fail to
find a connection signal from the
baby unit, the corresponding red
warning symbol appears. The connection
setup is attempted for one minute, before
patrol mode switches to the next camera/
baby unit.
If the connection problem recurs the next
time the baby unit is accessed in the patrol
mode loop, check the connection to this
baby unit. This baby unit might need to be
re-registered (see "Adding a camera" on
page 58).
6.8 Setting the VOX sensitivity
level
Babies normally make a number of different
sounds when awake. These can range from
gentle sighs to babbling to loud sounds of
distress or demands for attention. The VOX
function can be adjusted so that only louder
sounds that typically indicate distress or
calls for attention are transmitted, while
gentler sounds are not.
The VOX function allows you to set the
sound sensitivity of the microphone. The
higher the VOX level is set, the more
sensitively the device reacts to sounds.
1. Press the button 26.
The menu bar with the main menu will
appear at the bottom of the screen.
2. Use the
select the Settings menu.
The selected symbol will be shown in red.
3. Press the
submenu.
VOX: setting the sound sensitivity level
Display: This menu allows you to switch
from video
monitoring only, or select the "LCD Auto
Off" option for the screen.
4. Use the 25 or
star in front of "VOX".
5. Press the
submenu.
6. Use the 25 or
lower the sensitivity level.
The more bars you can see, the more
sensitively the device will react to sounds
in baby's room.
You have a choice of 5 levels:
VOX level 1 = very low sensitivity:
transmission activated only if baby is very
loud
VOX level
transmission activated if baby cries or
calls loudly
VOX level
transmission activated if baby cries or
calls at a normal volume
VOX level
transmission activated even by small
sounds
VOX level 5 = very high sensitivity:
continuous transmission of all sounds.
ECO mode is switched off.
At this point, you can still exit the
submenu by pressing the
The submenu will close and you will be
returned to
However, to continue with your settings,
continue with the next step.
62
24 or 27 button to
button 26 to view the
monitoring to
28 button to move the
button 26 to view the next
28 button to raise or
2 = low sensitivity:
3 = normal sensitivity:
4 = high sensitivity:
button 27.
the previous submenu.
audio