Sensitivity; Temperature; Vibration - NUK Eco Control Mode D'emploi

3. select and confirm the desired lullaby or select ALL to play all the lullabies one after
another
If one lullaby is selected it is played repeatedly for 15 minutes* (*chapt. 10) and than stops
automatically. If you want to stop it earlier, repeat the instructions above, but set STOP to stop
the playing.
If the setting ALL is selected, all the lullabies are played one after another. The playing lasts in
total around 3 minutes* (*chapt. 10). It stops automatically.
If Full Eco Mode is enabled, first press the M button two times in order to switch the
Note
lullabies on or off from the parent unit.
Note Lullabies may also be played directly on the baby unit (chapt. 7.2.2).

Sensitivity

With the on-screen menu you can set the sensitivity with which the baby unit's microphone picks
up the sounds and transmits them to the parent unit:
1. press the M button to open the menu
2. scroll to SENSITIVITY
3. select and confirm your desired sensitivity
Level 1: activated by loud sounds ..... Level 5: activated by quiet sounds
You need to determine the ideal level for your needs by trial and error.
Note

Temperature

At the top of the screen on the parent unit the temperature of the room in which the baby unit is
located is displayed (chapt. 1.3.1). It can be shown in degrees Celsius or degrees Fahrenheit.
With the on-screen menu you may set a minimum and a maximum temperature limit. An alarm
sounds whenever one of those limits is exceeded.
1. press the M button to open the menu
2. scroll to TEMPERATURE
3. select FORMAT, MINIMUM, MAXIMUM or ALERT
4. with FORMAT set CELSIUS or FAHRENHEIT
with MINIMUM set the minimum temperature limit
with MAXIMUM set the maximum temperature limit
with ALARM set the temperature alarm ON or OFF
When the temperature alarm is switched on, the indicator
the parent unit screen (chapt. 1.3.1). The alarm sounds even if the volume has been set off. The
alarm sounds once and a message 'TEMPERATURE TOO HIGH' or 'TEMPERATURE TOO
LOW' appears repeatedly on the screen.
You cannot disable the indication of the temperature and the visual warning.
Note
Note The displayed temperature is merely indicative and not a precise value.

Vibration

With the on-screen menu you can set the parent unit to alert you with vibration. If the baby unit
detects a sound, the screen is switched on and the parent unit vibrates 3 times in quick
succession (independent if Full Eco Mode is switched on or off). It also works with volume set to
"volume off" at the parent unit.
appears in the middle of the top of
44