Connection Check; Connections Reception Strength Indicator; Battery Indicator - NUK Eco Control Mode D'emploi

2. Install the mains adapters (chapt. 3.1.1) or the battery (chapt. 3.1.2) at the parent unit.
3. Switch on the baby unit by briefly pressing the
2 to 3 seconds to switch the baby unit off.)
4. Switch on the parent unit by briefly pressing the
for 2 to 3 seconds to switch the parent unit off.)
As soon as the parent unit is switched on, the connection indicator
rapidly and the parent unit starts searching for the baby unit. Once the baby unit has been
found, this indicator will light continuously or will start flashing at a slow pace.
If you do not comply with the above described order the parent unit will show the message 'NO
LINK' on the screen.
5.1

CONNECTION CHECK

The connection is checked regularly by the baby monitor. When (and as long as) the parent unit
is in contact with the baby unit, the connection indicator
When the baby unit gets out of range (or is switched off) the connection indicator
parent unit will start flashing. If the connection is not restored within 30 seconds, an alarm will
sound every 10 seconds. Once the connection between the parent unit and the baby unit is
restored, the connection indicator
Check the connection regularly during normal operation.
16
5.2

CONNECTIONS RECEPTION STRENGTH INDICATOR

In the upper left-hand corner of the screen on the parent unit (chapt. 1.3.1) is an indication of
the strength of the signal being received from the baby unit.
: very good reception,
In all three cases, audio and video data is shown with the same quality. As soon as the strength
of the signal being received from the baby unit is insufficient to receive audio and video data the
indicator lights up. At the same time the message
few seconds the screen goes black, and the connections reception strength indicator starts
flashing rapidly. If any button on the parent unit is pressed, the screen lights up with the
message 'WAITING FOR CONNECTION...'. After approximately 10 seconds, the screen goes
black again. As soon as the parent unit and the baby unit are back in range of each other, the
screen lights up again continuously.
The connections reception strength indicator also starts flashing and the
Note
message appears on the parent unit screen when the baby unit is switched off or the
batteries of the baby unit are empty.
5.3

BATTERY INDICATOR

Both, the parent and the baby unit have indicators to show the power status of the batteries.
The parent unit has a battery indicator on the unit (chapt. 1.3). On the screen it has a battery
level indicator (chapt. 1.3.1). The position and functionality of those indicators are described in
these chapters, but also in chapt. 3.1.4. An additional
The baby unit has a battery indicator on the unit. Its position and functionality is described in
chapt. 1.4. An additional
will be lit steadily again.
: good reception, : reasonable reception
is found in chapt. 3.2.2.
Note
button. (Keep this button pressed for
button. (Keep this button pressed
on the parent unit will be lit steadily.
'NO LINK' appears on the screen. After a
is found in chapt. 3.1.2.
Note
40
(chapt. 1.3) flashes
on the
'NO LINK'