Handling Instructions For The Battery; Charging The Battery - NUK Eco Control Mode D'emploi

4. Slide the battery cover back on to the parent unit.
If no battery is inserted into the parent unit, the unit can still be powered using the mains
Note
adapter (chapt. 3.1.1).
Only use the supplied Li-Polymer battery or replace it with a Li-Polymer battery of the
same type and specification.
8
The use of any other battery can cause damage to the device.
If the battery level indicator (chapt. 1.3.1) shows
Note
switch off in approximately 5 minutes* (*chapt. 10).
3.1.3

Handling Instructions for the Battery

Improper use of the battery may cause heat, fire, rupture, damage, or capacity
deterioration of the battery. Please read and follow the handling instructions before use.
9
Handling instructions:
1. Neither put the battery into a fire nor heat the battery. Do not store the battery in high
temperature environment.
2. Insert the battery correctly so that the battery contact completely touches the
terminals of the parent unit.
3. Do not let the battery contacts or parent unit terminals contact a wire or any metal
(like a metal necklace, keys or a hairpin) with which it is carried or stored together. It
may cause short-circuit.
4. Do not drive a nail in, hit with a hammer, or stamp on the battery. Do not strike the
battery in other ways.
5. Do not disassemble or alter the battery's outside structure.
6. Do not submerge the battery in water. Do not wet the battery when stored.
7. The battery was inspected carefully before shipment to conform with the
specifications. However, in case any abnormality (bad smell, heat etc.) arises after
purchase, bring the battery back (chapt. 11).
3.1.4

Charging the Battery

As soon and as long as you connect the parent unit to the mains adapter and plug the adapter
into a mains plug, the battery is being charged.
There is a battery indicator on the parent unit (chapt. 1.3). When the mains adapter is
connected to mains: It lights up when and as long as the battery is being charged. It turns off
when the battery is full. With a disconnected mains adapter the battery indicator is a power
on/off indicator: Then the light turns on when the parent unit is turned on, the light turns off
when the parent unit is turned off.
Moreover, there is a battery level indicator on the top right position of the screen of the parent
unit (chapt. 1.3.1). It shows the remaining power of the battery. The battery level indicator is
animated while the battery is being charged.
If instead of the battery level indicator the symbol of a mains plug lights up, the battery
Note
has not been inserted.
Before using the unit for the first time or after a long period of time: Charge the battery for at
least 15 hours, even if the indicator shows that the battery is full. When the parent unit is
battery empty the parent unit will
37