NUK Eco Control Video Display 550VD Mode D'emploi page 62

5. To delete a camera, use the
or 28 button to select the Delete
camera submenu.
6. Press the button 26 to view the next
submenu.
An overview
registered cameras/baby units.
7. Use the 25 or
star in front of the camera you wish to
delete.
At this point, you can still exit the
submenu by pressing the
The submenu will close and you will be
returned to the previous submenu.
However, to continue with your settings,
continue with the next step.
8. Press the button 26to confirm your
selection.
You will be asked to confirm
your selection again.
9. Use the 24 or
button to select "YES" and
press the
confirm.
The screen of the parent unit will
show that the camera is being
deleted.
As soon as the camera has been
successfully deleted, you will hear
a beep and the appropriate
symbol will appear on the screen.
The menu on the parent unit will be
closed and video transmission from the
active camera/baby unit will be shown.
If you delete the camera/baby unit that is
currently active, the parent unit will show
the video transmission from camera/baby
unit 1.
Note: After 15 seconds without any input
from you, the menu will be closed with the
settings unchanged and the parent unit will
return directly to monitoring mode.
25
appears showing
28 button to move the
button 27.
27
button 26 to
Delete failed
If the camera delete attempt fails, an
appropriate
appears. You will also hear a beep.
The parent unit will then switch back to the
video transmission from the previously
the
active camera/baby unit.
10.Follow steps 1 to 9 described above and
try again.
Manually switching between
cameras
If more than one camera/baby unit is
registered on the parent unit, you can select
one of these cameras for continuous
monitoring.
1. Press the
The menu bar with the main menu will
appear at the bottom of the screen.
2. Use the
select the Camera menu.
The selected symbol will be shown in red.
3. Press the
submenu.
4. Use the
move the star in front of the "Add
camera" setting.
5. Press the
submenu.
An overview appears showing camera
symbols. Camera numbers under which a
camera/baby unit is registered are shown
in green.
6. Use the
star in front of the camera you wish to
use for continuous monitoring.
At this point, you can still exit the
submenu by pressing the
The submenu will close and you will be
returned to
However, to continue with your settings,
continue with the next step.
7. Press the
selection.
60
warning symbol
button 26.
24 or 27 button to
button 26 to view the
25 or 28 button to
button 26 to view the next
25 or 28 button to move the
the previous submenu.
button 26to confirm your
button 27.