Filling The Blender Jug While The Blender Is Running; Removing The Blender Jug From The Motor Unit - SilverCrest SSM 550 E1 Manuel D'utilisation

SilverCrest SSM 550 E1
Speeds 1 to 3 For mixing, blending and pureeing liquid or semi-solid foods
Speeds 3 to 5 For chopping and for more solid foods
Ice Crush/Clean For crushing ice and short pulses at high speed. Also for cleaning the cutting blades.
The rotary switch does not remain engaged in this mode to avoid excess strain on
the motor. You should therefore only ever use this function for a very brief period.
To crush ice, you should fill the blender jug (3) with a maximum of 180g of ice cubes.
Otherwise the ice will not be perfectly crushed.

Filling the blender jug while the blender is running

Warning!
When the blender is running, only ever open the measuring cap (1) and not the entire blender
jug (3) lid (2). Otherwise rotating food could be catapulted out.
When the measuring cap (1) is open, never insert cutlery or other items into the blender jug
(3). There is a danger of injury!
Proceed as follows to add ingredients while the blender is running:
1. Rotate the measuring cap (1) in an anti-clockwise direction and remove it.
2. Add the desired ingredients to the blender jug (3).
3. Close the measuring cap (1). To do so, insert it into the lid (2) and tighten in a clockwise direction.

Removing the blender jug from the motor unit

1. Place the rotary switch (4) in the Off position. If you are finished blending, disconnect the mains plug
from the wall outlet.
2. Once the motor has stopped running, lift the blender jug (3) vertically off the motor unit. There is no
need to rotate the blender jug (3) to do this.
76 - English