Operation; Fitting And Filling The Blender - SilverCrest SSTME 600 B1 Mode D'emploi

Operation

►
Fitting and filling the blender
1) Rotate the blender 3 anticlockwise until the arrow
handle is located above the
motor block 6 in a vertical, upward motion.
2) Remove the lid 2 by rotating it anticlockwise towards position
until you can pull it upwards.
3) Fill the blender 3 to at least to the lowest line of the scale 8 and at most to
the MAX mark. For optimum results, we recommend the following maximum
filling quantities:
Yoghurt-based drinks
Vegetable soup
SSTME 600 B1
WARNING!
The motor switches off automatically as soon as the blender 3 is removed
from the motor block 6 or the lid 2 is opened. In such cases it may be
easy to forget that the machine is still switched on. The motor will then start
unexpectedly as soon as the blender attachment 3 is fitted or the lid 2 is
closed again:
Therefore:
–
Do not insert the power plug into the wall socket until the blender 3 is
filled and mounted with its lid fitted and closed.
–
Before fitting the blender, always check to see that the appliance is
switched off or that the power plug has been removed.
–
Switch the appliance off first, pull the plug out and wait until the motor
has come to a standstill before removing the blender 3 or opening the
lid 2.
Food
Liquids
Milkshakes/
smoothies
Pancake mix
Baby food
Mayonnaise
Ice cubes
position. Remove the blender 3 from the
Max. filling
mended
quantity
1750 ml
1250 ml
1250 ml
1250 ml
750 ml
2 eggs
250 ml oil
1500 ml
250 ml
(approx. 14‒15
pieces)
under the blender
Recom-
Recommended
processing time
level
1‒3 60 sec.
2‒5 90 sec.
2‒5 60‒90 sec.
3‒5 90 sec.
5 3 min.
3‒5 90‒120 sec.
3‒5 3 min.
P 12x
GB │ IE
(see Fig 1)
│
7 ■